How does Data Collector Operation（Guide Video)

- 七月 18, 2018

The data collector is for hotel lock system, to get the opening record from the locks, latest 240pcs of door-opening history can be recorded. You will know who, when, how, to open the hotel door locks.

How to use Data Collector

Step 1. Install Battery

Disassemble the hard case of the data collector from its back to install 4pcs standard AAA（1.5V） alkaline batteries. Remove the batteries if the data collector won't be used in near time.

Step 2. Program Record Card

Put a card on the card encoder that already connected the computer and program a Record Card in the door lock management software by following the steps below.

Step 3. Collecting Door-Opening Data

A. Use the Record Card to Swipe the door lock in the induction area, blue light appears with one beep.

B. Turn on the data collector during blue light, put collecting head to the lock induction, within 30mm.

C. Take it away from the lock until hearing a sound “Di” from door lock and data collector at the same time, the reading process is about 10~50 seconds.

Step 4. Upload Door-Opening Data

A. After door-opening data is collected successfully, turn off the data collector (and keep it off during the reading process) and connect it to computer.

B. Click “Report” button on the software, and select“Report of Open Door”, then click “UpLoad” button at the bottom-left corner.

C. During the uploading process, the led light on data collector will flash in red and green. When it turns to green light(no flash) and with a long beep, data uploading succeed. Refresh the display page and the new door-opening data will show on the system.